Instructions for a Bell & Howell 8mm Projector By G.K. Bayne; Updated September 15, 2017. Once developed, you set up your Bell & Howell 8mm projector and enjoyed the memories made on the film. Place the projector on a sturdy table or desk at least eight feet from the projection screen or wall.

I find this directions for the Bell & Howell Auto Load 8mm Super Movie Projector: Super 8 is a small format motion picture film that came into widespread use in the 1960s and '70s. Prior to Super 8's introduction to the home movie market in 1965, the most common formats were 8 and 16 mm. Super 8 widened the frame without widening the film, making it possible to project Super 8 and 8 mm film through the same projectors. One ubiquitous model was the Bell and Howell Autoload. Folder lock for windows 8 64 bit with crack kickass torrent free. Raise the reel arms upward and outward.

Put the takeup reel on the back arm and the processed roll of Super 8 film on the front arm. The end of the film should point toward the projector. Push the power switch all the way up so that the light comes on. You will hear the projector motor fire up. Make sure the direction lever that sticks out of the middle of the projector horizontally is set to forward rather than in reverse.

Press down on the upper loop former, the lever just below and to the left of the front reel. Line the end of the film up with the opening in the front of the loop former and let the projector pull it through. The film will wind through the sprockets and begin to spool out at the bottom of the projector.

Let go of the upper loop former and pull the film underneath the guide rollers at the bottom left and right corners of the projector. The film will continue spooling through slowly. Allow it to do so until it is long enough to reach the takeup reel. Slip the end of the film leader into one of the holes in the center of the takeup reel. Your film will begin to project as soon as the leader spools all the way through.

Additionally, here can find some details: - - Hope this helps, Posted on Jul 09, 2011.

Before digital camcorders, before VHS tape cameras, the 8mm film camera was popular for making home movies. Although 8mm is silent film, the cameras were popular during the 1960s and '70s, as they were affordable and film was available in most stores. Even the local drugstore could send your film off for processing and development. Once developed, you set up your Bell & Howell 8mm projector and enjoyed the memories made on the film. Place the projector on a sturdy table or desk at least eight feet from the projection screen or wall.

Open the cover of the projector by pressing the lever button on the top and removing the cover by tilting it backward from the machine. Lift the front reel arm up and lock it in place. Do the same with the back reel arm. The front reel is for the movie reel, while the back is for the take-up reel. Place the film reel on the front arm by attaching it through the center hole of the reel. Ensure that the film drops from the reel in a clockwise manner. Attach the take-up reel to the back arm in the same way.

Press down on the level just in front of the projector lens to reveal the loop former that threads the machine. Insert the end of the film into the loop former. Plug the projector into an electrical outlet and turn the knob on the front of the machine to 'Projector.' Continue to hold the loop former lever down until the film advances through the machine automatically. Release the lever when the film appears on the opposite side of the projector. Grasp the film by the end and gently pull until you have enough film to reach the take-up reel, plus several inches. Turn the projector to the 'Off' position.

Insert the end of the film into the slot on the center of the take-up reel spindle. Turn the take up reel in a clockwise rotation until the film has wrapped around the spindle two to three times and the film is taut between the projector and take-up reel. Turn on the projector; the film will begin to play automatically.