To create fix firmware reset for printers Samsung CLP-320 CLP-325 N / W / K necessary to know and This information can be found by printing the reports of the printer: si ~ 3 seconds STOP / CLEAR until the LED starts blinking – print report ~ 8 seconds STOP / CLEAR until light stabilizes – print report In the 2nd part ( ) can see – How simple it is to install fix firmware reset sent by us – Working cartridge without chip (covered with tape or taken out) – Counters reset to 100% after each stop/ start the printer After reset is necessary only refill toner cartridge. Reset procedure will cancel all 4 chips from cartridge and also chip from image unit DRUM. Video refill cartridge CTL-406 h.

[Brian] really liked his Samsung color laser printer right up until it was time to replace the toner cartridges. A full set of toner cartridges sell for about the same price as the printer itself, so [Brian] figured he could simply refill the toner in the cartridges he already has. The printer sends out the ‘low toner’ warning based on page count and won’t print if the page count is too high, negating the economy of a toner refill kit. Luckily, [Brian] figured out a so he can use those third-party refill kits. All the configuration settings and page counts for the printer are stored on an I2C EEPROM.

Hacking the Samsung CLP-315 Laser Printer 03 March 2012 on Arduino, CLP-315, Hack, I2C, Printer. I am the happy owner of a Samsung CLP-315 laser printer. It is a fantastic printer for the price. Things were going great until it came time to replace the toner. At the time, the price of a full set of toner cartridges was around $150.

After dumping the data held on this EEPROM with an Arduino and sniffing everything going into the EEPROM with a Bus Pirate, [Brian] was nearly at his wit’s end. Thankfully, serendipity intervened.

When [Brian] restarted the printer with the Bus Pirate attached, he noticed it took much longer to initialize. Printing a configuration report, he was trilled to see that all page counts have been zeroed. The final hack that allows [Brian] to reset the page count and used refilled toner cartridges is a simple wire that ties the SDA line of the EEPROM to ground on boot.

[Brian] used a momentary switch, but given this is a once-every-few-months operation, a simple wire would suffice. Check out [Brian]’s page reset demo after the break.

• • • • Posted in, Tagged,,, Post navigation. I’ve done something very similar for years with my samsung clp-300 (color laser).

I used a simple LPT port interface and ponyprog software. As said, the printer just counts pages. Download computer aided design and manufacturing by dr sadhu singh pdf free. And wastes a lot of toner if i just replace the half empty cartrige. My problem was, the printer engages a writelock on the chip if the maximum capacity is reached, making it impossible to reset the chip. At first, i solder new chips onto the tiny boards (Atmel 34c02 like the original) then i read about someone using similar chips but with a write protection pin. With that chip and engaged hardware lock the printer can not write on the chip.